• FuzzyDog@lemmy.world
    link
    fedilink
    arrow-up
    15
    arrow-down
    5
    ·
    6 days ago

    I have no fear of cooking with it, I just want my cookware to be minimally fussy and not require special treatment. If the $10 Walmart skillet can be thrown in the dishwasher and the $100 cast iron one requires me to baby it or it’ll rust, I’ll go with the cheap skillet every day.

    • AA5B@lemmy.world
      link
      fedilink
      arrow-up
      18
      ·
      6 days ago

      Teflon also should not go in the dishwasher. Anything with exposed aluminum should not go in the dishwasher. Even stainless steel cookware recommends against dishwasher

    • RBWells@lemmy.world
      link
      fedilink
      arrow-up
      7
      ·
      6 days ago

      You have those prices reversed though. My cast iron collection, as noted further down, cost less in total than my one really good stainless steel pan, and guess where some of that cast iron was purchased? For $10 at Walmart, LOL. And at thrift stores and Target.

    • rumba@lemmy.zip
      link
      fedilink
      English
      arrow-up
      7
      arrow-down
      1
      ·
      6 days ago

      First, everyone (not you because you don’t like it) should buy their cast iron at the hardware store, should be ~ $30. It’ll last pretty much forever so that $30 over a lifetime is not much.

      If you don’t cook a starch or aromatic in it, just wipe it out and let it get super hot.

      If you do cook starch in it, hand wash it with soap, just let it get over 212 degrees on the stove to dry it.

      If you want to throw it in the dishwasher, just pull it out at the end of the cycle and throw it on the stove > 212 degrees to dry. A well seasoned pan is generally so easy to clean, this would be a waste of your time, but it won’t kill anyone.

      If you want to subscribe to the no soap, scrub off the cooked starches with water and a non scratch scouring pad, re-coat in a fine layer of oil and let it smoke off under high heat. I really don’t bother and just use whatever it takes to get it clean easily.

      If the seasoning polymer you get from burning off oil gets cruddy after 6-8 months, re-season.

      If you accidentally get a little rust on it, soak it in vinegar until the rust dissapears, scrub the spot with a 3m pad until the spot is clean and re-season.

      You can get a rusty ass pan from a yard sale, soak it in vinegar for a day, scrub it down and re-season it. It’ll come out like new.

      If over the years, the seasoned surface starts to look super cruddy, soak it in sodium hydroxide until the polymer disolves, then reseason.

      Yeah, they’re harder than throwing it in the dishwasher, But they’re wasteless, cheap, pleasant to cook on and give great results.

      I keep a teflon pan and a couple different cast iron around. Even found a glass top lid that fits.

      • aport@programming.dev
        link
        fedilink
        arrow-up
        6
        arrow-down
        9
        ·
        edit-2
        6 days ago

        Lol this response proves OP’s point. “Bro it’s so easy bro just soak in sodium hydroxide and fill your house with smoking oil it’s easy dude just measure how much starch is in ur meal dude lol ez”

        • TowardsTheFuture@lemmy.zip
          link
          fedilink
          English
          arrow-up
          4
          ·
          6 days ago

          These are instructions for those who are picky about stuff.

          Just cook in it. After cooking, wipe it out. If its bad, when pre-heating I pull it off to put some water and rub with a pad with minimal soap, rinse that off, and back on the hob. Wow 15s of work before cooking. The horror.

          The instructions rumba gave were “if you absolutely fuck up, here are easy ways to fix that so you don’t have to buy a new one”

          • hardcoreufo@lemmy.world
            link
            fedilink
            arrow-up
            2
            ·
            6 days ago

            Yup I usually just dry scrub with a little chainmail scrubber to get all the bits off with. Then I wipe down with a little veg oil and it’s ready for next time.

        • rumba@lemmy.zip
          link
          fedilink
          English
          arrow-up
          2
          arrow-down
          1
          ·
          6 days ago

          LOL at cherrypicking something I said to do instead of throwing the pan away

    • untorquer@lemmy.world
      link
      fedilink
      arrow-up
      4
      ·
      6 days ago

      Tbf the cast iron i’m cooking out of was found as scrap in the woods. I wash with soap regularly, and use normal oil/butter qty’s. I just don’t dishwasher it, not that i have a dish!asher XD. I’ve seasoned it one single time which is right after i found it. It’s been a year.

      • Ensign_Crab@lemmy.world
        link
        fedilink
        English
        arrow-up
        6
        ·
        6 days ago

        You might want to check that for lead. People who cast their own bullets have been known to melt lead in cast iron.

        • untorquer@lemmy.world
          link
          fedilink
          arrow-up
          2
          ·
          6 days ago

          Ehhh… I’ve taken the 100LL avgas shower. At this point, a year of cooking later, the damage is done ig. Ill grab a test kit tho.

    • Bluewing@lemmy.world
      link
      fedilink
      arrow-up
      1
      ·
      5 days ago

      Look at Ol’ Diamond Jim over there with his $100 skillets!

      I got 2 cast iron frying pans, a 6qt dutch oven, a 2 burner flat iron, and one cast iron 2qt kettle. I ain’t got $50 into the whole lot of them. Vintage cast iron is cheap because it will last for multiple generations and there is lots of it floating around to be had on the cheap.

      And if you ain’t got 5 minutes to clean a cast iron frying pan, then no $10 nuclear glow int the dark Walmart special is going to do any better in your care. I highly recommend you find someone to cook for you. Before you give yourself food poisoning.