What are your bed temps for PLA and ASA? Does it still happen if you preheat the bed? If you rotate the print, does the rough spot follow the rotation?
What are your bed temps for PLA and ASA? Does it still happen if you preheat the bed? If you rotate the print, does the rough spot follow the rotation?
DAK catalogs were wild. Each item had a magazine article length description that was clearly bullshit. But by the end you’re certain that the constant emptiness you feel is from not owning the World’s Best 16 Channel Stereo Graphic Equalizer.
An alkaline AA may have more capacity, but the LiPo has lower internal resistance and it’s electrolyte is flammable. The worst the alkaline would do it shorted or punctured is get warm and poop out KOH.
Other than niche Keysight gear that’s has three layers of nameplates because it’s '90s vintage NOS, LXI and USB-TMC have replaced GPIB.
He’s daydreaming about going all Gordon Ramsay on the LKML after the photo shoot.
During CPU startup Transmeta’s Dyson “It” style campaign leading to their first product launch, they widely publicized that Linus was on staff.
Ironically you chose a picture of Linus holding a laptop containing the only product he’s famous for shilling.
$ :|wc -c 0 $ touch /tmp/f; :>>/tmp/f; wc -c /tmp/f 0 /tmp/f
Like that time Keurig used a very special shade of orange on the lid of their pods as DRM?
Applying power by itself doesn’t keep SSDs from degrading like DRAM though. It’s up to the manufacturer to design scrubbing into the controller to correct errors on infrequently accessed data before it’s too far gone.
“fill angle” under infill settings.
If you’re piping any of those commands to or from awk, you can also go.
Yep. I can get ASA down to 12% with an ambient 50%RH using that method.
There are some models out there for wedges with reverse Bowden fittings so you can keep it cracked open all the time.
Try running your dryer with the lid propped open a bit. Most Sunlu dryers don’t have a way to get rid of the humid air pulled out of the filament.
Thanks to Alec I have strong opinions about extension cords and gas lanterns.
deleted by creator
Then they trip balls, see their life flash before their eyes, and become a space baby. Could be worse.
Up until a few years ago there was a local urologist named Richard Chop, and Dr. Peter Ruff is still seeing clients. Nominative determinism is a thing.
PLAYERS: 0
Problem solved.
I think your bed is warping slightly as it heats up, which is normal. Set your bed temp to 105 for half an hour before starting your print and see if it still happens. If you have a V0 or other manually levelled printer, get the bed to 105 before levelling.